Waeco PerfectView CRT300 Instrucciones De Montaje Y D’uSo página 49

– When laying the cable ensure that it is:
1. not bent or twisted,
2. does not rub over edges,
3. is not routed through sharp-edged holes without protection.
– All holes in the outer skin of the vehicle require protection against the
penetration of water by way of suitable measures e.g. by inserting
the screws with sealing compound and sealing the cable and grommet
with sealing compound.
Attention: The system plug connection does not provide any
protection against the ingress of water. Make sure that you seal
the connection point using a sealing strip. A self-vulcanising
sealing strip, e.g. from 3M, is best suited.
TIP: To minimise corrosion inside the connector we recommend
inserting some grease, e.g. pole grease, into one of the
connectors.
Using the branch connector
To prevent loose connections at branch connections it is important for
the cable cross section to fit the branch connectors.
The blue branch connectors included in the installation kit are suitable for
cables with a diameter of 1 mm
diameter of your selected cable, use the thickness of the monitor
connection cable as a means of orientation. If the cable selected by you
has the same thickness, the blue branch connector will fit.
Perform the following steps to use the branch connector:
1. Lay the cable which is to be tapped into the front groove of the
branch connector (see . H 1).
2. The end of the new cable is inserted by approx. 3/4 into the rear
groove (see . H 2).
3. Close the connector and use an all-purpose wrench/combination
pliers to press the metal ridge into the connector to produce an
electrical connection (see . H 3).
4. Press down the protective cap until it engages on the connector.
Test the branch connection by pulling on the cable (see . H 4).
Producing correctly soldered joints
To connect a cable to original leads:
1. Strip 10 mm from the original lead (see . H 5).
2. Strip 15 mm from the cable to be connected (see . H 6).
All manuals and user guides at all-guides.com
Laying the cables
2
to 2.5 mm
2
. If you are not sure of the
49