Waeco PerfectView CRT300 Instrucciones De Montaje Y D’uSo página 50

3. Twist the cable to be connected to the original lead and solder
(see . H 7).
4. Insulate the cable with insulating tape (see . H 8).
To connect 2 cables together:
1. Strip both cables (see . H 9).
2. Pull an approx. 20 mm long shrink-down plastic tubing over one of the
cables (see . H 10).
3. Twist both cables together and solder (see . H 11).
4. Pull the shrink-down plastic tubing over the soldered joint and heat
slightly (see . H 12).
Laying the cable from the monitor to the camera
u Route the camera connection cable into the vehicle.
u Route the connection cable from the monitor to the camera
(see . H 13).
u Connect the camera connection cable to the extension cable.
u Apply at least 2 layers of good quality insulating tape over a length of
200 mm to insulate the plug-in connections (see . H 17).
u Securely fasten the cable in the vehicle to provent entanglement (risk
of tripping) using binders, insulating tape (see . H 15 and H 16) or
by gluing with adhesive.
u Do not start sealing the holes until all camera setting work has been
completed and the required connection cable lengths have been
determined.
For parts required for routing the cable from the monitor to the
camera see . H 13 to H 16.
Attention: The system plug connection does not provide any
protection against the ingress of water. Make sure that you seal
the connection point using a sealing strip. A self-vulcanising
sealing strip, e.g. from 3M, is best suited.
Further extension cables are available from your dealer or from WAECO
on request:
Length Art. No.
5 m RV-405
10 m RV-410
15 m RV-415
50
All manuals and user guides at all-guides.com
Laying the cables