Main Menu; Pac - Pilot Arc Current; Auto Operation; Analog Inputs - Cebora PW30 Manual Instrucciones

5.4

AUTO operation.

AUTO mode offers two options for starting a pilot arc.
1) From power source WIN TIG if interfaced with a robot or CNC (*)
2) From connector CN3 of the PW30 unit (see section 4.4.3).
Operation of CN3 depends on the status of the parameters shown in the table:
Operating modes
Auto (L3 on)
OFF (L2 on).
NOTE
The interface with the robot is active (Robot function ON) it is also possible to issue the pilot arc start command from
CN3.
5.4.1

Analog Inputs

The operation of analog input ANALOG IN1 is dependent on the position of dip switch SW2-3 on panel board pos.15
of console PW30;
The operation of analog input ANALOG IN2 is dependent on the position of dip switch SW2-4 on panel board pos.15
of console PW30;
The factory setting of dip switches SW2-3 and SW2-4 is OFF.
If the WIN TIG power source is interfaced with a robot, the analog setpoints from the robot take priority over analog
inputs AN1 and AN2 of CN3. If the robot does not manage these analog signals (enablement bit on bus inactive), the
CN3 inputs return to operation but are dependent on the position of the relevant dip switches in all cases.
6

MAIN MENU

The main menu is represented by the three parameters shown on displays D1, D2 and D3 when the console is turned on
with the plasma welding unit enabled (section 5.1).
6.1 PAC – Pilot Arc Current.
Pilot arc current
Shown by display D1 (with L2 on) and adjustable with M1 when L4 is on.
Range = 3.0 ÷ 30.0 A.
Default = 10.0 A.
From the TIG touch panel: MENU -> Plasma Welding Parameters -> Pilot Arc Current.
3301069/A
Robot function
ON
OFF
x
SW2-3
OFF
ON
NOTE
SW2-4
OFF
ON
Pilot arc start
from CAN bus CN2-WIN TIG
from CN3-PW30
from key T1
Analog IN1
disabled
enabled
Analog IN2
disabled
enabled
EN
41/48