Operating Modes; Plasma Welding Process Enablement - Cebora PW30 Manual Instrucciones

5

OPERATING MODES.

5.1

Plasma welding process enablement

For correct console operation, follow the instructions in section 3.2 of the following manual. Once the hardware con-
nections have been made, enable the plasma unit from the TIG power source user interface as described below:
- From main screen of the TIG power source:
3301069/A
Select the Menu key:
Select Accessories and then choose option
:
Welding Unit
Set
Plasma Welding Unit
This gives access to all the settings and control
thresholds available under
After setting these parameters,
go back to the main
menu
Plasma
to ON:
Plasma Console PW30
by pressing key
EN
39/48