Stryker 8203-133-000 Manual Del Usuario página 4

EN
WARNINGS:
▪ Upon initial receipt and before each use, operate the
equipment and inspect each component for damage. DO
NOT use any equipment if damage is apparent. See the care
instructions manual supplied with the handpiece.
▪ ALWAYS slide the function switch to the safe mode position
when the handpiece is idle, before installing an attachment or
accessory, or when passing the handpiece to another person.
▪ DO NOT attempt to install or remove an attachment or
accessory while the handpiece is operating.
▪ DO NOT operate the handpiece in the drill mode position
when a reamer attachment and/or accessory is installed in the
handpiece.
▪ Before operating the handpiece, ALWAYS gently tug the
attachment and accessory to make sure the attachment
is securely locked in the handpiece and the accessory is
securely locked in the attachment.
▪ ALWAYS operate the equipment within the specified
environmental condition values. See the instructions for use
supplied with the handpiece.
▪ ALWAYS follow the recommended duty cycle to prevent the
equipment from overheating. See the instructions for use
supplied with the handpiece.
▪ DO NOT grasp or touch any rotating component while the
handpiece is operating.
▪ DO NOT disassemble or service this equipment without the
authorization of the manufacturer.
CAUTION: ALWAYS store the equipment within the specified
environmental condition values throughout its useful life. See the
instructions for use supplied with the handpiece.
NOTE: When used with handpieces, the attachment described
in this manual is an applied part. For more information, see the
instructions for use supplied with the handpiece.
4
8203-133-700 Rev-AA
www.stryker.com