B- Fitting The Handle; C- Door Reversibility - Eurocave V 292 Manual Del Usuario

5 - i
nstalling your Wine CaBinet
b - Fitting the handle
The handle is supplied in the accessories sachet which you will find inside your
wine cabinet.
To fit it (example for a right-sided door):
• Adjust and centre the handle (2) on the three fastening studs, then press the
handle downwards to secure it, see Fig.1
• You can slot the remote control (1) into the handle (2), see Fig.1

1
Fig. 1
c - Door reversibility
The door of your wine cabinet is reversible.
In this way, you can change the direction in which it opens.
To do so, follow the instructions below (example for changing a right-sided
door into a left-sided door):
• Close the door
• Carefully remove the grommets (3-4) using a thin blade, see Fig.2
•Unscrew the three screws (5) using a "T25" Torx wrench, see Fig.2
•Remove the upper hinge (6), see Fig.2

Fig. 2
• Remove the door of the cabinet by opening it slightly, then lifting it
upwards
N.B.: The door is heavy. Take all necessary precautions so that you do not
injure yourself or drop it
• Carefully remove the grommet (7) using a thin blade, see Fig.3
• Unscrew the pin (8) with the washer (9), then screw it back onto the
same part, on the opposite side using a 10 mm spanner, see Fig.3
• Reposition the grommet (7), on the opposite side, see Fig.3
7
Fig. 3
• Put the door back onto its pin (8), remembering to also replace the
washer (9), see Fig.4
9
8
• Put the hinge in place (6), using the three screws (5) so that the door is
parallel to the cabinet, see Fig.5
• Check that the door seal adheres properly to the cabinet (by closing the
door), in order to ensure optimal sealing
• Put the grommets in place (4).

5 6
6
Fig. 4

5
Fig. 5
9
8
7

9
GB