General Information; General Warnings - Wonder SPA Manual Del Usuario

INFLATOR GAUGE

GENERAL INFORMATION

The inflator gauge is designed, manufactured and calibrated in Italy,
using the most advanced technologies in compliance with European
Directive 86/217/EEC
Wonder carefully checks the origin and quality of all materials and
components used in production to offer its customers high quality
products that are guaranteed and also to reduce the impact on the
environment to a minimum. Our quality systems are ISO 9001 and
ISO 14001 certified. You are invited to observe the local laws and
regulations regarding this product to prevent accident or injury and
also control the general safety regulations for the use of this product.
Wonder denies any liability for any errors in measurement or
damage that could be caused by the following: incorrect or
inappropriate use of this product or any of its single components;
not following the instructions provided in this manual; use by
unqualified individuals; unauthorized modifications or alterations
to this product. This device is designed for intended use only,
i.e. measurement, inflation and regulation of internal pressure of
motor vehicles tyres. Any other use is considered inappropriate.
Models with Pe scale (bar only)
2

GENERAL WARNINGS

• Once the gauge is connected to the tyre, briefly operate the handle and the
exhaust valve 2/3 times to give elasticity to the instrument, then proceed
with the inflating/deflating operation.
• During inflation, maintain a safe distance to avoid injury due to accidental
bursting of the tyre.
• Never block the handle in the inflating position as this would result in a
continuous flow of air into the tyre that would produce a high risk of the
tyre exploding.
• Check that the pressure from the compressor is higher than the pressure
recommended by the tyre manufacturer.
• Ensure that the air or nitrogen from the compressor passes through a
separator filter to prevent liquids (e.g. hydrocarbons) or other impurities
from entering into the inflator gauge causing oxidation of the internal
components and damaging the system of measurement.
• Constant or prolonged use when the instrument is under pressure using
pressured air or nitrogen can, in the course of time, alter the variables of
the measurement system producing an incorrect reading on the dial. It is
therefore recommended that the instrument is not left in use for long periods.
• Our inflator gauges are designed to measure maximum pressures within
the range of the single gauge.
• To obtain best results, the operating temperature should be between 15°
and 25°C.
• Avoid knocks to the inflator gauge - do not disassemble.
• Do not expose to bad weather conditions or direct sunlight and avoid
sudden changes in temperature.
• Do not submerge in water or detergents. Clean the instrument using a damp
cloth.
and UNI EN 12645
2
10
WONDER SPA
.
2