General Rules - Beninca CP.J3 Manual De Instrucciones

Control units for 24Vdc motors with powers under 120W.
a) The electrical installation and operating logic must comply with statutory regulations.
b) Cables of different voltages must be physically separated or otherwise adequately screened with
secondary insulation of at least 1 mm.
c) Cables must be secured by additional clamps next to their terminals.
d) Control all wiring connections are correct before powering.
e) Check the Dip-Switch settings are correct.
f) Unused N.C. inputs must be jumpered.
Terminals Function
(1-2) Antenna
5 COM
6 Step by Step
7 STOP
8 PHOT
JP7 24Vdc Motor
JP1 Encoder
14-15 Blinker
16-17 24 Vac
JP4 Secondary
J3 Radio Receiver
N.B.: To control the automation during installation, the Step by Step button on the control unit can be
used.
8
Control units CP.J3

GENERAL RULES

INPUT/OUTPUT FUNCTIONS
Description
Optional antenna connection to built-in radio receiver board (1-
signal/2-screen).
If external antenna connected cut wire welded to "ANT".
Common for all control inputs.
Step by step button input (N.O. contact)
STOP button input (N.C. contact)
Input for safety devices, N.C. contact (e.g. photocells)
In close cycle: if the contact opens, the motor will stop and will in-
stantly reverse direction (opening).
In open cycle: disabled.
Jack for 24Vdc motor
Insertable connector plug to connect an encoder:
A: + Encoder
B: S Signal of Encoder
C: - Encoder
Blinker connection, 24Vac/15W max.
Accessory power supply 24Vac/1A max.
IMPORTANT: If the battery charger board JM.CB is installed, the
output (without mains power connected) has a 24Vdc polarised
voltage. Make sure the devices are correctly connected.
(i.e. 16:+24Vdc - 17:-24Vdc).
Secondary circuit of the transformer.
18 Grey: 0V output
19 Red: Slowdown speed.
Connect the Faston to the 20V output
20 Brown: 24V output
21 White: Motor speed.
See section "Motor speed adjustment "
Built-in radio receiver