Descargar Imprimir esta página

Stryker ST1 Serie Manual Del Usuario página 31

Ocultar thumbs Ver también para ST1 Serie:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 191
C C l l e e a a n n i i n n g g
C C l l e e a a n n i i n n g g t t h h e e p p r r o o d d u u c c t t
These instructions provide recommended cleaning methods for the Stryker Model 6300 S S T T 1 1 and S S T T 1 1 - - X X Series stretcher.
Recommended cleaning method
1. Remove the mattress from the product.
2. Follow the cleaning solution manufacturer's dilution recommendations.
3. Hand wash all surfaces of the product with warm water and mild detergent.
4. Avoid over-saturation and make sure that the product does not stay wet longer than the cleaning solution
manufacturer's guidelines for proper cleaning.
5. Do not place the mattress on the product until the product is dry.
6. Check functionality before you return the product to service.
Raise and lower the product
Lock and unlock the brake/steer pedal in both positions
Latch and unlatch the siderails
Raise and lower the Fowler backrest
Make sure that all components have proper lubrication
Make sure that jack does not stick due to dust or debris
Make sure that all labels are intact
N N o o t t e e
• Do not steam clean the product.
• Clean the base hood storage area.
• Clean the bottom of the brake pads to prevent wax or floor remnant buildup.
• Some cleaning agents are corrosive in nature and may cause damage to the product. If you do not rinse and dry the
product well, a corrosive residue may be left on the surface of the product that could cause premature corrosion of
critical components. Failure to follow these cleaning instructions may void your warranty.
R R e e m m o o v v e e i i o o d d i i n n e e
1. Make a solution of 1 to 2 tablespoons of sodium thiosulfate in a pint of warm water. Use the solution to wipe down the
stained area.
2. Clean the stain as soon as possible after the stain occurs.
3. If stains are not immediately removed, allow solution to soak or stand on the mattress before you wipe the mattress.
4. Rinse the mattresses which have been exposed to the solution with clear water before you return the mattresses to
service.
N N o o t t e e - - Failure to follow these directions when you use these types of cleaners may void this product's warranty.
S S p p e e c c i i a a l l i i n n s s t t r r u u c c t t i i o o n n s s
V V e e l l c c r r o o ® ®
Solids or stains
KK-6300 Rev 00
Saturate with disinfectant, rinse with water, and allow the
solution to evaporate.
Use neutral soaps and warm water. Do not use harsh
cleansers, solvents, or abrasive cleaners.
27
EN

Publicidad

loading

Este manual también es adecuado para:

St1-x serie6300