Metrohm 774 Oven Sample Processor Manual De Instrucciones página 129

Ocultar thumbs Ver también para 774 Oven Sample Processor:
Tabla de contenido

Publicidad

5.11.4.6
5.11.4.7
5.11.4.8
5.11.4.9
774 Oven Sample Processor, Instrucciones para el uso
5.11 Description of the remote control commands
.Keyboard
Disables all keys of the keyboard, except the
<START>, STOP> and <CLEAR> key.
.Config
Locks the configuration menu
.Parameter
Locks the parameter menu
.Usermeth.Recall
Locks the function "recall method"
.UserMeth.Store
Locks the function "store method"
.Usermeth.Delete
Locks the function "delete method"
.Display
Disables the LCD display. The instrument will not sup-
port the display.
Setup.Mode.StartWait
Indefinite start delay. Only for remote control.
Setup.Mode.SendMeas.Sendstatus
Setup.Mode.SendMeas.Intervall
Automatic sending of the current measured values defined below at a se-
lectable interval (in seconds).
Setup.Mode.SendMeas.Meas.CyclNo
Setup.Mode.SendMeas.Meas.OvenTemp
Setup.Mode.SendMeas.Meas.GasFlow
Definition of the measured values to be sent automatically, see above.
Setup.AutoInfo.Status
Setup.AutoInfo.P
Setup.AutoInfo.Ch.G
Setup.AutoInfo.Ch.GC
Setup.AutoInfo.Ch.R
Setup.AutoInfo.Ch.S
Setup.AutoInfo.Ch.H
Setup.AutoInfo.Ch.C
Setup.AutoInfo.Ch.B
Setup.AutoInfo.Ch.F
Setup.AutoInfo.Ch.OM
Setup.AutoInfo.Ch.CM
Setup.AutoInfo.Heater.T
Setup.AutoInfo.Heater.S
Setup.AutoInfo.E
"on" means, the instrument automatically sends a corresponding message
when the specified event occurs.
.Status
Enables/disables the preset AutoInfo messages
.P
PowerOn: Simulation of PowerOn (see 5.11.4.10). Not from
mains.
Messages from changer functions:
.Ch.G
Go: Method has been started
.Ch.GC
Go Command: Start command has been received
.Ch.R
Ready: Status 'Ready' reached
.Ch.S
Stop: Status 'Stop' reached
.Ch.H
Hold: Status 'Hold' reached
.Ch.C
Continue: Resuming after Hold
.Ch.B
Begin: Begin of sample sequence
.Ch.F
Final: End of sample sequence
.Ch.OM
"Opening Moves": Begin of start sequence
.Ch.CM
"Closing Moves": Begin of final sequence
.Heater.T
Target: Change of target temperatur
on, off
on, off
1...4...999
on, off
on, off
on, off
on, off
on, off
on, off
on, off
on, off
on, off
on, off
on, off
on, off
on, off
on, off
on, off
on, off
on, off
on, off
123

Publicidad

Tabla de contenido
loading

Tabla de contenido