Operation The Unit; User Interface - aquatermic MCO18124D5812-05 Manual Del Usuario

1 OPERATION THE UNIT
1.1 USER INTERFACE
Electrical heater
ON/OFF button
Unit ON/OFF button
UP adjust button
1.2 OPERATIONS
1. Power 'ON'
When turning 'ON' the power, whole icons are displayed on the controller screen for 3 seconds. After checking if everything is
ok, the unit enters into the standby mode. Water temperature and clock time are displayed on the screen.
2. button
By pressing this button for 2" when the unit is in standby mode, the unit is turned 'ON' and runs on the setting mode. The
running mode, set temperature and water temperature, clock time and timer situation are displayed on the screen.
By pressing this button for 2" again when the unit is running, the unit is turned 'OFF' and enters into the standby mode.
3. and buttons
- These are the multi‐purpose buttons. They are used for temperature setting, parameter setting, parameter checking, clock
adjustment and adjustment of the timer.
- During running status, press or button to adjust the setting temperature directly.
- By pressing these buttons when the unit is on clock setting status, the hour(s) and the minute(s) of the clock time can be
adjusted.
- By pressing these buttons when the unit is on timer setting status, the hour(s) and the minute(s) of the timer 'ON'/'OFF' can
be adjusted.
- Check and adjust the set parameters:
3) When the unit is 'OFF' or 'ON' (not on clock and timer setting status), short press
Set button
Clock/Timer setting button
DOWN adjust button
button to entry the user
15