10. Mounting The Cabinet Door Handle, Door Latch; Inserting The Ash Clean-Out Tray; Placing The Grease Tray - Pit Boss PRO Serie Manual Del Usuario

Ocultar thumbs Ver también para PRO Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10. MOUNTING THE CABINET DOOR HANDLE, DOOR LATCH

Parts Required:
1
x
Cabinet Door Handle (#9)
1
x
Cabinet Door Latch (#10)
1
x
Cabinet Door Heat Filter (#11)
2
x
Screw (#C)
2
x
Screw (#D)
Installation:
First, remount the Cabinet Door to the Main Cabinet by aligning and
securing both hinges. Ensure the door is mounted correctly by testing
that it opens freely.
Next, mount the Cabinet Door Handle onto the front side of the
Cabinet Door using two screws (C). Note correct direction in 10A.
Install the Cabinet Door Latch and Door Latch Heat Filter onto the
exterior side of the Main Cabinet using two screws (D). Note 10B.
IMPORTANT: Fine tune and test the Cabinet Door Latch and Hooks
to ensure they align properly and there is a proper seal while the
Cabinet Door is closed. Poor alignment may result in heat loss and
leaks during use.

11. INSERTING THE ASH CLEAN-OUT TRAY

Parts Required:
1
x
Ash Clean-out Tray (#22)
Installation:
Open the Cabinet Door. Next, insert the Ash Clean-out Tray into the
Ash Clean-out Housing on the front panel of the unit, below the Front
Shelf. Tighten the bottom screw counterclockwise to lock into place.
IMPORTANT: Ensure the Ash Clean-out Tray is inserted completely to
properly collect ash from the Main Cabinet.

12. PLACING THE GREASE TRAY

Parts Required:
1
x
Grease Tray (#19)
Installation:
Slide the Grease Tray into the Grease Tray Brackets on the back
underside of the Main Cabinet.
NOTE: The Grease Tray is completely inserted once the front of the
tray is flush with the back of the Main Cabinet.
10A
9
C
10B
11
10
11
22
12
19
D
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pro pbv4ps919310259276049255025

Tabla de contenido