Procedure To Install General Roll Media To The Take-Up Reel Unit - Oce CS6407 Guía De Consulta Rápida

Procedure to install general roll media to the take-up reel unit

1
Prepare a paper tube and attach it to the
scroller fl anges.
(1) Insert a scroller fl anges into each edge of the paper
tube.
Scroller fl ange
(2) Insert the fl ange spacer between the scroller fl ange
and the media roll.
Note
- When PVC media is used, push the scroller fl ange until it
stops without inserting the fl ange spacer.
- The fl ange spacer should be inserted to the position
indicated by the line B.
Be careful not to deform it by applying too much force.
B
(3) Push the scroller fl ange until it stops and turn the
handle clockwise until the fl ange is fi xed to the paper
tube.
Scroller fl ange
(4) Remove the fl ange spacers.
All manuals and user guides at all-guides.com
2
Note
- If the printer processing proceeds to the next step with the take-
Paper tube
3
Note
- Hook the tension bar to the tension bar hook beforehand.
A
4
Handle
Set the take-up direction switch to OFF.
up direction switch set to ON, your hand may be caught as the
scroller is not secured.
Take-up direction switch
OFF
Attach the scroller fl ange by fi tting it with the
roll groove of the printer.
Roll groove
Tension bar hook
Tension bar
Feed the media with the FORM FEED MENU on
the operation panel to an extent where it can
be taken up.
Outer take-up
- OFF
Inner take-up
Scroller fl ange
11