Oce CS6407 Guía De Consulta Rápida página 8

4
Attach the scroller shaft clip.
(1) Slip the scroller shaft clip on the scroller shaft.
(2) Turn the knob to fi x the scroller shaft.
Knob
5
Install the media roll fi tted with the scroller
fl anges into the printer roller groove properly.
Scroller fl ange
Flange support
6
Install the fl ange holders.
Cap side
7
Remove the protection bar and open the front
cover.
8
All manuals and user guides at all-guides.com
Scroller shaft clip roll ll l l
1
2
g y
Printer rea Printer rear (supply side)
Wiper side
Front cover
Protection bar
8
Move the media edge guards to each side so
that they are not under the media.
Media edge guards
9
Rotate the pressure control knob clockwise to
raise the pressure roller.
Takeup side
Pressure control knobs
10
Insert the media end into the paper feeder
while smoothing out the media by hand to
prevent wrinkles.
Paper feeder
If it is hard to insert the media end into the paper
feeder due to a curl of the media, interpose an interleaf
and insert the media end under the interleaf as shown
in the fi gure.
- Up curl - Down curl
Supply side
or
Printer rear