Operating Buttons - Ecolab EcoAdd Instrucciones De Servicio

Control/software
Cleaning the touch-sensitive control panel (touchscreen)
CAUTION!
To clean the touch-sensitive control panel, it is recommended to use a
microfibre cloth.
– To avoid damaging the surface of the control panel, do not use any
unsuitable cleaning agents.
– When cleaning, do not apply too much pressure to the control panel in
order to avoid damaging the pressure sensor.
– Never clean the control panel by spitting on it and then rubbing it.
This will cause a smeared film to form on the control panel, which will have
to be cleaned again.
– Never use aggressive or scouring techniques or detergents.
– Never use products which contain ammonia.
Ammonia can damage the control panel.
– Do not spray liquids or water directly onto the control panel. Otherwise,
there is a risk of ingress and damage inside the device. Spray the liquid
onto the microfibre cloth instead and squeeze it out in order to remove all
excess liquid before it is used for cleaning.
– Never use paper towels or tissue paper.
They contain wood fibres which can scratch the plastic surface. Scratches
will possibly not be visible initially, but the surface will appear matt and
blurred over time.

Operating buttons

"Main menu" button: Call the main menu.
"Menu" button: Call the higher-level menu.
"Next" button: Call/show the next setting display.
"Plus" button: Adjust a value into the positive range.
"Minus" button: Adjust a value into the negative range.
"Delete character" button: Delete digits, letters or entire words.
"Cancel" button: Cancel ongoing applications (e.g. calibration).
"Confirm" button: Confirm ongoing applications (e.g. calibration).
"Start" operating mode Switch the pump to "Start" operating mode. The symbol changes to the pause
symbol "
"Pause" operating mode Switch the pump to "Pause" operating mode. The symbol changes to the
Start symbol "
"Test" button
Pressing the 'Test' button (continuous run) displays 'Test' on the screen and conveys product until this
button is released again. This is very helpful when venting the metering line, for example.
Level signal (standard with Bluetooth module):
Neutral display permanently displayed = empty signal is monitored using suction lance. Press the button
to perform a 'product change' :
Level indicator (without Bluetooth module):
Neutral display permanently displayed = Empty signal is monitored via the suction lance. Press the
button to perform a 'product change' :
on page 149 .
Maintenance Information
Shows upcoming maintenance together with the number of weeks until the maintenance is due.
Press this button to access the 'Pump service' menu:
on page 153 .
MAN046939 Rev. 6-10.2021
".
".
Ä Chapter 10.3 'Changing the container - Empty signal' on page 149 .
Ä Chapter 10.3 'Changing the container - Empty signal'
Ä Chapter 10.4 'Confirming pump service'
56