Basic Safety Instructions - Conergy IPG T Serie Instrucciones De Servicio

2 Safety
6
| The correct country-specific parameter set is selected from
the display;
| The product is used only in the countries intended
(Belgium, Germany, France, Greece, Spain, Portugal, Italy,
Czech Republic, Slovakia, Bulgaria, Poland, Austria,
Switzerland, Luxembourg and the Netherlands);
| Packaging material is disposed of in an environmentally
friendly manner.
2.2

Basic safety instructions

Before starting any work on photovoltaic systems, note the
following safety rules:
| Disconnect the unit.
| Ensure that the unit cannot be switched on again.
| Verify that the system is fully deenergised.
| Earth and short-circuit the unit.
| Cover adjacent live parts.
| First connect the power cable and then the solar power
system wiring, since PE is connected with the power cable.
| A second person must be present.
In the event of an unforeseen electrical accident, that
person must be able to switch off the power supply and
provide assistance.
| There are high DC voltages present. These may cause
arcing if a malfunction occurs or if plugs or safety devices
are improperly used.
| The connected power source is permanently enabled.
Depending on the operating status, voltage from the solar
power system may be supplied to the inverter. This must be
noted in particular when disconnecting from the mains.
| The inverter cooling element and choke can reach a
temperature of up to 100 °C when in operation.
Operating manual
Conergy IPG T series