Descargar Imprimir esta página

Warning Signals - CYBEX ANORIS T i-SIZE Manual Del Usuario

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 46

WARNING SIGNALS

The indicators on the display panel (5) are activated as soon as at least one
ISOFIX locking arm is connected to the vehicle. Pay attention to the following
warning signals:
Incorrect installation of ISOFIX Locking arms
Both ISOFIX Locking arms have to be anchored correctly.
Incorrect installation of the load leg
The load leg must be fully extended and correctly braced
against the floor.
Impact shield not buckled in
Check if the buckle tongue is buckled in.
Malfunction
Finish your journey as planned and then contact the dealer
or manufacturer.
Battery charge status < 30%
The batteries should be changed soon.
Battery charge status < 10%
The batteries must be replaced at the earliest possible time
��
To check the current status of the indicators, press the check button.
FOLDING IN THE LINEAR SIDE-IMPACT PROTECTION
To fold in the Linear Side-impact Protection (L.S.P.) (1), proceed as follows:
1. Pull the headrest (12) into its uppermost position and fold the headrest cover
upwards to reveal the L.S.P locking button (23).
2. Close the Linear Side-impact Protection (L.S.P) (1) and keep it pressed down.
Push the L.S.P locking button (23) outwards.
3. As soon as the L.S.P locking button (23) is pushed out to its furthest extent,
the Linear Side-impact Protection (L.S.P) (1) can be released.
To fold out the Linear Side-impact Protection (L.S.P.) (1) again, press firmly on the
area on the L.S.P. marked with "PRESS".
PRODUCT CLEANING AND CARE
The cover consists of 3 components which are attached to the car seat at several
points. Loosen all fixings. Then the individual parts can be removed. Make sure you
only remove the top cover of the impact shield.
To reattach the cover, proceed in reverse order.
Only the removable cover of the car seat may be washed at 30°C on a delicate
��
cycle. Please wash the cover separately from other laundry and never machine
dry it! Do not dry the cover in the blazing sun!
WARRANTY AND DISPOSAL REGULATIONS
CYBEX GmbH (Riedingerstr. 18, 95448 Bayreuth, Germany) gives you
3 years warranty on this product. The warranty is valid in the country in
which this product was first sold to a consumer through retail channels.
The contents of the guarantee and all essential information required
for the assertion of the guarantee can be found on our homepage
go.cybex-online.com/manufacturer-warranty-car-seats. If a guarantee is
stated in the article description, your statutory rights against us for defects remain
unaffected.
The car seat and its components are special waste and must not be
disposed of with household waste. The product must be disposed of in
accordance with regional regulations. All current information on disposal
in your country can be found at
go.cybex-online.com/anoris-t-isize-disposal.
EN
9

Publicidad

loading