Sliding Guide; Rear Fitting - APRITECH HOME 60 Manual Del Usuario

6 ASSEMBLY

6.1 Sliding guide

If you use a sliding guide in two pieces, you must assemble it,
as explained below. If you have a pre-assembled guide, go
on to paragraph 6.2.
1) Assemble the two pieces of the sliding guide, fitting them in the
central joint (Fig. 6 ref. A) until they come to a stop against the
metal reference reliefs (Fig. 6 ref. B). To facilitate engaging the
sliding guide, we advise you to insert it in the central joint, com-
pressing it as shown in Fig. 6 ref. C. Do not use tools which could
deform the guide or joint.
2) Slide the transmission unit (Fig.7 ref. A) along the whole sliding
guide, until it is near the front terminal, the one opposite the drive
coupling.
3) Assemble the front fitting (Fig. 7 ref. B) to the transmission unit (Fig.
7 ref. A).
4) Apply slight tension to the chain, tightening the nut (Fig. 7 ref. C.).
5) Place the sliding guide on the side (Fig. 8).
6) Push the carriage toward the drive clutch unit (Fig.8
ref. C).
7) Adjust the tensioner (fig. 8 ref. A) so that the central zone of the
loop, formed by the top branch of the chain, coincides with
about the mid-point of the sliding guide (Fig. 8 ref. B)
Attention: too much tension can cause damage to the
transmission and drive clutch units.

6.2 Rear fitting

Before securing the sliding guide to the ceiling, assemble the rear
fitting in the seat of the drive clutch unit and fasten the screws as
shown in Fig. 9 ref.
Fig. 6
Fig. 7 Fig. 9
6
.
Fig. 8