External Release (Optional); Installation; Sliding Guide - APRITECH HOME 60 Manual Del Usuario

6.3 External release (optional)

If the external release system has to be installed, the cable
must be placed in its seat before beginning to install.
1) Release the carriage (see par. 7.4 point 3), and take it to
the slot on the top of the sliding guide.
2) Fit the cable terminal on the red seat (Fig. 10).
3) Take the carriage back toward the drive clutch unit until
the through-hole on the carriage coincides with the slot, and fit
the unsheathed cable (Fig. 11).
4) Fu l l y w i t h d r a w t h e c a b l e f r o m t h e b o t t o m o f t h e
carriage.
5) Wind the cable around itself to prevent it getting in the way while
the sliding guide is being installed.

7 INSTALLATION

- To ensure you work in safe conditions, we advise you to
install the operator while keeping the door fully closed.
- Use all the specified anchorage points.
- The fastening systems must be suitable for the type of
support and sufficiently tough.
- Protect your hands and face adequately while drilling
the holes.
- Read this chapter to the full before you begin
installing.

7.1 Sliding guide

When you have finished the preliminary assembly operations,
you can begin installing the sliding guide, as follows:
1) On the architrave, mark a line corresponding to the vertical mid-
point of the door (Fig. 12).
2) On the architrave, mark a horizontal line corresponding to the
maximum height reached by the door during movement (see
Fig. 4).
3) Position the securing bracket of the front fitting, so that the lower
edge is at least 5 mm above the intersection point of the lines
and centred with respect to the vertical line (Fig. 12). Also refer to
paragraph 7.2 for correct positioning of the bracket with respect
to the fitting point on the door.
4) Mark the two securing points.
5) Next, drill and install, using the screws (ref.
6) Position the sliding guide on the floor, perpendicular with respect
to the door.
7) Raise the guide from the front fitting and assemble the fitting with
the securing bracket using the relevant pin and clamp (Fig. 13).
Fig. 10
Fig. 11
7
Fig. 12) NOT supplied.
Fig. 12
Fig. 13