Accessories; Central Support; Key-Operated Release; Safety Edge - APRITECH HOME 60 Manual Del Usuario

16 ACCESSORIES

16.1 Central support

The central support (Fig. 34) provides a central securing point also
for the single-piece sliding guide.

16.2 Key-operated release

The external release can be installed with the lever system
(Fig. 35 ref. A) or the key system (Fig. 35 ref. B). See instructions in par.
6.3 and par. 7.5.

16.3 Safety edge

The use of the safety edge with conductive element, is
facilitated because the control unit (Fig. 36 ref
housed on board the operator.
Procedure:
- Grip the rear door with one hand.
- Pull gently, separating it from the plastic housing.
- Grip the ceiling light with one hand.
- Pull gently, separating it from the plastic housing.
- Unscrew the 4 screws in the 4 corners of the plastic housing.
- Separate it from the base.
- House the control unit as shown in Fig. 36.
- First hook on the two fastening clips on the coupling on the base.
- Then press lightly until you can hear the hooking snap sound.
- For the connections, refer to the specific instructions for the safety
edge, and Fig. 27 of these instructions.

16.4 Battery kit

Fig. 34
The buffer battery kit will activate the automated system in the event
of a power cut. The batteries are housed inside the operator (Fig. 37
ref. ) fastened by a supplied screw.
To install, consult the specific instructions.
Fig. 35
) can be
15
The batteries come into operation when a power cut occurs.
After installing the batteries, connect the male
connector to the J12 female connector on the control
board.
Fig. 36
Fig. 37