General Safety Rule; Starting The Machine - La Pavoni EUROPICCOLA/A Manual De Instrucciones

English
1
picture C
picture D
- Insert the main cable plug into an electric socket
with adequate voltage (please refer to the plate
under the base of the machine), picture C.
- Place the switch (6) on the ON position and wait
for the machine to reach the required pressure
(about 5 minutes), place a container under the unit
(11), slowly lift the lever (1) completely and hold
it in this position so as to fully discharge the water
contained in the boiler. Subsequently switch the
machine off and remove the plug from the power
socket, open the steam tap knob (4) anticlockwise
and wait until all the steam has been discharged
from the steam pipe (12) provided, open the
boiler cap (3) anticlockwise and turn the machine
upside-down to eliminate all the remaining water
from the boiler. Fill the boiler again with fresh
water and use it to rinse of the machine inside to
eliminate any residues of the solution.
6.1 – GENERAL SAFETY RULE
If the pressure inside the boiler exceeds the maximum
pressure, for any anomaly, the system will activate
the safety valve (2) which it will start whistling and,
by opening, will start to abundantly discharge steam
through the condensation basin, picture D.
Switch the machine off, avoid any manipulation and
refer to the authorised SERVICE CENTRE.
52
7 – STARTING THE MACHINE
Fill the boiler (9) with an amount of water that is proportional to the amount of coffee you wish to make (the capacity
of the machine is equivalent to 8 cups of espresso coffee for the Europiccola and Stradivari models and to 16 cups
of espresso coffee for the Professional and Stradivari Professional models).
The amount of water will not have to exceed the top part of the level glass
(5) and will not have to drop below the visible lower part of the same, picture
A.
6
7
picture E
1
4
5
6
picture E
English
EUROPICCOLA MODEL
- Press the switch (6) which, by lighting up, will indicate
that the machine is on; at the same time the warning light
(7) will also switch on indicating that the heating element
is activated, picture E.
- Wait for the warning light (7) to switch off; turn the steam
tap knob (4) slowly, by turning it anticlockwise, and
discharge the "false pressure" due to the air that is left in
the boiler; then close it again by turning it clockwise. The
warning light will switch on again; wait for it to switch
off. Now the machine has reached the correct pressure
and is ready to deliver coffee and steam. When the
green lamp starts blinking alternatively it is due to the
normal functioning of the machine, which automatically
regulates the pressure in the boiler.
PROFESSIONAL MODEL
- Place the switch (6) on the on position; lighting it up, will
indicate that the machine is on, picture E.
- When the pointer of the pressure gauge (13) will have
reached the green zone, turn slowly the steam tap knob
(4) by turning it anticlokwise, to discharge the "false
pressure" due to the air left in the boiler; then close it
again by turning it clockwise and wait for the pointer of
the pressure gauge to reach the green zone. Now the
machine has reached the correct pressure and is ready
to deliver coffee and steam. The pressure will be automa-
tically regulated and maintained by the pressure switch
which acts on the heating element.
53