Replacing The Screen Guard - NAMCO MAZAN Manual Del Operador

7-5

Replacing the Screen Guard

1. Seperate the Monitor Base Assy from the Front Assy.
2. Remove the Signboard Assy.
3. Remove the Front Panel.
4. Remove 2off security screw (M5x25) and 4off pozi head screws (M5x16), and
remove the Monitor Mask.
Security screw
(M5 x 25)
Projector mask
5. Remove 18off Whizz nuts, and remove the two pairs of Guard Brackets (A),(B),
and remove the screen guard.
Guard bracket (A)
Whizz nut
Projector mask
(rear side)
6. Reassemble in reverse order.
Note: The front and rear sides of the Screen Guard are different. Ensure that the
Screen Guard is re-fitted the correct way round.
(see 5-3 page 36)
(see 7-2 page 66)
Pozi head screw (M5 x 16)
Whizz nut
Guard bracket (B)
Screen guard
Page 69
(see 5-2 page 35)
Security screw
(M5 x 25)
Whizz nut