Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
1. These instructions should be used to mount the REESE
ensure a quick, safe and quality installation. Check parts against Figure 1 to become familiar with kit.
2. Before installing REESE
the leaf spring must be greased as shown using
white lithium grease or equivalent (see Figure 7). For
best results, use aerosol white lithium grease with a
spray nozzle extension. Make sure entire
underside of spring is coated! Repeat this application
monthly during use.
3. Before setting the REESE
into the bed of the pickup. Insert the bent
handle(3) through drivers side assembly(2)
(driver's side of towing vehicle) and then
through passengers side slide assembly(1). Slide
straight handle(9) over bent handle(3). Install roll
pin(10). See Figure 8.
Hint: It may be easier to lay the handles on a firm
surface to install the roll pin. Then insert the
handle into the drivers and passengers assemblies.
When installing handle grip (8), rotate it so the
molded finger areas align for your use. Either left
hand or right hand usage.
4. Set the REESE
™
FIFTH Wheel Slider into
base rails and pin in position as shown in
Figure 9 below.
Slide Upright
Figure 9
BASE RAIL
50024N – 11/19/14
REV H
™
FIFTH Wheel Slider,
™
FIFTH Wheel Slider
Slide Tube
PCN4441
©2011, 2014 CEQUENT PERFORMANCE PRODUCTS, INC.
™
FIFTH Wheel Slider. Care and attention to detail will
Aerosol white lithium
grease spray with nozzle
extension
Figure 8
Leaf spring
Figure 7
Safety label facing
driver side.
(10)
WARNING:
Pull pin spring clips must
be on the outside of base rail
as shown. (Spring clips
installed on the inside of
base rail will not allow Slider
to move far enough to lock).
Sliders that are not properly
locked can suddenly move
and cause serious injury or
death.
Printed in China
4
Publicidad
