Publicidad
Idiomas disponibles
Idiomas disponibles
5. Loosely assemble head support to REESE
NOTE: Bottom position may not be used on all hitch models.
Use the cotter pins(4) and indicator pin(6) to trap handle(3) in
place as shown. Be sure pin is installed in handle as shown. Install so that
the indicator pin is in both slots of the casting. (See Figure 11).
6. Snug up all bolts and nuts.
Torque 1/2" bolts to 85 ft. lb.
7. Coat top surface of slide tube and roller holes in each
slider assembly with all purpose grease or Teflon lube, use
as needed (see Figure 12). Repeat this application monthly
during use.
LEAF SPRING
SLIDE TUBE
LOCK WASHER
LATCH
& BOLT
BOLT-ON FOOT
Slide hitches that are not properly locked can suddenly move and kill you!
•Never place any part of your body in the truck bed or between the truck and the trailer
unless each and every one of the following conditions are met :
1. Truck is in park with emergency brake on, and
2. All trailer wheels are blocked on each side of wheel.
•Always perform "push test" or "pull test" by following the instructions in this manual.
50024N – 11/19/14
REV H
™
FIFTH Wheel Slider at desired height.
Cotter pin (4)
On back side
Figure 11
Indicator pin (6) in both
slots of the latch casting.
ROLLER
END CAPS
WELD-ON FOOT
WARNING:
To avoid death or serious injury:
PCN4441
©2011, 2014 CEQUENT PERFORMANCE PRODUCTS, INC.
(3)
Cotter pin (4).
On back inside.
ROLLER HOLES
Figure 13
FRONT OF TOW VEHICLE
Figure 10
Indicator pin (6)
SLIDE TUBE
Figure 12
5
Printed in China
Publicidad
