SEA MERCURY Serie Instrucciones De Instalación página 7

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
12. RELEASE SYSTEM WITH PLASTIC LOCK
12.1. To release procede as follows:
- Insert the key, push and turn about 90° clockwise (Fig. 23).
- Pull the release lever until it stops, about 90° ( Fig. 24).
Note: when pulling the release lever the electronic control unit receives a stop impulse through the micro-switch placed on
the inside (if present).
12.2. To relock procede as follows:
- Push the release lever to complete closing.
- Rotate the key counter-clockwise and extract it.
Once the lock has been restored the electronic control unit is reactivated (only if a micro-switch is mounted) .
O p e n
C lo s e
Fig. 23
13. RELEASE SYSTEM WITH METAL LOCK
13.1. In order to release do as follows:
-Open the lock cover, insert the key and rotate it 90° clockwise (Fig. 25).
- Pull the release lever until it stops, about 90° approximately (Fig. 26).
Note: when you pull the release lever, the electronic control unit receives a stop impulse thanks to a micro-switch placed
inside.
13.2. In order to relock do as follows:
- Push the release lever to complete closing.
- Rotate the key counter-clockwise and extract it.
- Close the protective lock cover.
Once the lock has been restored the electronic control unit reactivates
e
C o s
l
Fig. 25
SAFETY PRECAUTIONS:
All electrical work and the choice of the operating logic should conform to current regulations. A 16 A 0,030 A differential switch must
be incorporated into the source of the operators main electrical supply and the entire system properly earth bonded. Always run
mains carrying cables in separate ducts to low voltage control cables to prevent mains interference.
SPARE PARTS:
To obtain spare parts contact:
SEA S.p.A. - Zona Ind.le, 64020 S. ATTO Teramo Italia
SAFETY AND ENVIRONMENTAL COMPATIBILITY:
Don't waste product packing materials and/or circuits.
When being transported this product must be properly packaged and handled with care.
SEA reserves the right to do changes or variations that may be necessary to its products with no obligation to notice.
67411230
®
Page for both instaler and user
Push and
turn
O p e n
Fig. 24
Fig. 26
ITALIANO ENGLISH
13