CMT ORANGE TOOLS CMT300 Manual De Instrucciones página 10

OPTIOnAL CMT300-T064 TeMPLATe
example of making a drawer with a standard CMT300-T064 template:
X4
Left-hand
side
X1
With each pass of the router, a complete assembly is machined on
the workpiece (X1 with Y1, X2 with Y2...), so to make a complete
drawer, four work cycles must be carried out.
Positioning the wood parts and machining:
1) Place the wood part (X1, X2....) vertically against the small
positioning buffer and clamp it sufficiently with the bar to ensure
it does not slip.
2) Place the wood part (Y1, Y2....) horizontally against the small
positioning buffer and clamp it sufficiently with the bar to ensure
it does not slip.
3) Level the two pieces of wood.
4) Tighten the clamping bar of the vertical part completely.
5) Tighten the clamping bar of the horizontal part completely.
6) Position the template and tighten the nuts to hold it in place.
7) Move up to and away from the workpiece from
the front - not from above - to avoid the risk of
missing the guide and ruining the joint.
8) Position the router and follow the profile of the
template to carry out the machining.
9) The first assembly is finished - repeat the
previous procedure as often as required.
10
Rear
Y4 Y3
X3
X2
Y1 Y2
Front
dismantled
drawer
Right-hand
side
Y4
X4
X1
X2
Y2
Y1
www.cmtutensili.com
Y3
X3