CMT ORANGE TOOLS CMT300 Manual De Instrucciones página 14

OPTIOnAL CMT300-T080 And CMT300-T127 TeMPLATe
Positioning the wood parts and machining:
1) Place the wood part (X1..., Y2....) vertically against the small positioning buffer and clamp it sufficiently
with the bar to ensure it does do not slip.
2) Place the piece of scrap stock horizontally and push it against the vertical piece.
3) Match the ends of the two pieces of wood.
4) Tighten the clamping bar of the vertical part completely.
5) Tighten the clamping bar of the horizontal part completely.
6) Position the template and tighten the nuts to hold it in place.
7) Move up to and away from the workpiece from the front - not from above - to avoid the risk of missing
the guide and ruining the joint.
8) Position the router and follow the profile of the template to carry out the machining.
9) The first assembly is finished - repeat the previous procedure as often as required.
14
www.cmtutensili.com