Optional Cmt300-T127 Template - CMT ORANGE TOOLS CMT300 Manual De Instrucciones

OPTIOnAL CMT300-T127 TeMPLATe

7) Optional CMT300-T127 template
The CMT300-T127 template can be purchased as an optional and enables to make box joints.
25.4mm
(1")
30/35mm
Box joints
(CMT300-T127)
12.7mm
(1/2")
Contents of the CMT300-T127 package:
29) CMT300-T127 template
14) Four M4x8mm screws
from
43) Two Ø7.8x7/Ø17.2x24 stop rings
CMT300
69) Two M4x40mm screws
44) Two Ø19.65x6mm stop rings
10) Two M4x16mm screws
23) 2.5mm hex key
from
CMT300
from
CMT300
Mounting the template: this template is mounted in the same way as the standard model. Remove the
standard template from the CMT300 system and replace it with template 29, fixing it on the supports (13 -
included in the CMT300 package), using the screws (14). The stop rings (43 and 44) replace those supplied
as standard. The two (longer) rings (43) are mounted on the front in F2, whereas the others (44) are fitted
on the front in F1 and only used for machining a particular structure, as can be seen in Fig.7. In this case,
the upper part of the wood is up against ring 44 and the lower part up against ring 43.
Upper part
Overhead view
Fig.7
Front view
Lower part
Fitting the guide ring: to use this template, it is necessary to mount the Ø15.8x4mm guide ring (35)
already on the CMT300. Then mount a CMT straight bit (812.127.11 with Ø6.35mm shank, 912.127.11
with Ø8mm shank or 812.627.11 with Ø12.7mm shank), which will carry out the machining.
12
www.cmtutensili.com