Optional Cmt300-T080 Template - CMT ORANGE TOOLS CMT300 Manual De Instrucciones

6) Optional CMT300-T080 template

The CMT300-T080 template can be purchased as an optional and enables to make mini box joints.
Contents of the CMT300-T080 package:
27) CMT300-T080 template
14) Four M5x8mm screws
39) Two Ø15x7/Ø21x18 stop rings
69) Two M4x35mm screws
40) Two Ø14x6mm stop rings
10) Two M4x16mm screws
34) Ø11.1x4 guide ring
22) Two M5x8mm screws
23) 2.5mm hex key
Mounting the template: this template is mounted in the same way as the standard model. Remove the
standard template from the CMT300 system and replace it with the other template (27), fixing it on the
supports (13 - included in the CMT300 package), using the screws (14). The stop rings (39 and 40) replace
those supplied as standard. The two rings 39 are mounted on the front in F2, whereas the others (40) are
fitted on the front in F1 and are only used for machining a particular structure, as can be seen in Fig.7. In this
case, the upper part of the wood is up against ring 40 and the lower part up against ring 39.
Fitting the guide ring: replace the guide ring already on the router with ring 33. Then mount a straight bit
(881.081.11 with Ø6.35mm shank or 912.080.11 with Ø8mm shank), which will carry out the machining.
www.cmtutensili.com
16mm
(5/8")
20/30mm
8mm
(5/16")
Overhead view
Front view
OPTIOnAL CMT300-T080 TeMPLATe
Mini box joints
(CMT300-T080)
from
CMT300
from
CMT300
Upper part
Fig.7
Lower part
11