Assembling The Cmt300 - CMT ORANGE TOOLS CMT300 Manual De Instrucciones

ASSeMBLInG THe CMT300

2) Assembling the CMT300
Fig. 1: The first job is to mount the CMT300 on the workbench. Four self-tapping screws are supplied for
this purpose.
Workbench
Fig.1
Unit
Fig. 2: This diagram enables to understand how to mount the components required to adjust the position
of the template. First of all, fit screw 15 in the hole of the body, using the hex key (supplied) and carefully
tightening it, fitting lock nut 2 on the other side, then fit washer 11 and tighten nut 12 manually. Repeat this
procedure on the other side of the body.
The components (3) and screws (10) are used to position the wood. Tighten the stops (3) on the body (1)
using the screws (10). Set the stops in the positions U1 on the top of the system and F1 on the front of the
system.
Workbench
Fig.2
Overhead view
Front view
Template
Fig. 3: : This diagram enables to mount the template 5.
Fit the two adjustable supports (13) on it with the four screws (14).
Fig.3
Fig. 4: This diagram shows how to install the clamping bars that will enable the workpiece to be held in place.
These bars have a sandpaper coating, which ensures more grip and therefore a better hold on the workpiece
during machining.
Fit the two screws with over-sized locking knobs (7) in the washers (8), in the bar (4) and in the spring (9).
5
www.cmtutensili.com