Optional Cmt300-T129 Template - CMT ORANGE TOOLS CMT300 Manual De Instrucciones

8) Optional CMT300-T129 template

The CMT300-T129 template can be purchased as an optional and enables to make 12.7x20mm open
dovetail joints.
20mm
Contents of the CMT300-T129 package:
31) CMT300-T129 template
14) Four M4x8mm screws
44) Two Ø21.85x6mm stop rings
14) Two M4x16mm screws
34) Ø11.1x4mm guide ring
22) Four M5x8mm screws
23) 2.5mm hex key
Mounting the template: this new template is mounted in
the same way as the standard model. Remove the standard
template from the CMT300 system and replace it with
template 31, fixing it on the supports (13 - included in the
CMT300 package), using the screws (14). The stop rings
(45) replace those supplied as standard and are mounted
on the front in F2.
Mounting the guide ring: it can be seen that this template has two sides, as the joint is made using two
bits: one for each side of the template. On the first (straight) side, the Ø12.7 dovetail bit (818.129.11 with
Ø6.35mm shank or 918.129.11 with Ø8mm shank) will be used, with the standard Ø15.8x4mm guide ring
(supplied with the CMT300), whereas on the other (dovetail) side, the Ø8mm straight bit (811.081.11 with
Ø6.35mm shank or 912.080.11 with Ø8mm shank) will be used with Ø11.1x4mm ring (34), supplied with
the template.
www.cmtutensili.com
12.7mm
(1/2")
OPTIOnAL CMT300-T129 TeMPLATe
Open dovetail joints
(CMT300-T129)
from
CMT300
Overhead view
from
CMT300
from
CMT300
Front view
15