CMT ORANGE TOOLS CMT300 Manual De Instrucciones página 17

OPTIOnAL CMT300-T129 And CMT300-T190 TeMPLATe
example of making a drawer with CMT300-T129 and CMT300-T190 template:
Rear
dismantled
drawer
X3
X4
Y4
Y3
Y1
Left-hand Right-hand
side side
Y2
X1
Front
With each completed run, an assembly is made (X1, X2...., Y1 Y2...), so to make a complete drawer, eight
work cycles must be carried out.
Using the two sides:
The first part of the template (with the straight slots) enables to make the X-axis cuts (X1, X2...), using a CMT
dovetail bit and the corresponding guide ring.
The second (dovetail) part of the template enables to make the Y-axis cuts (Y1, Y2...), using a CMT straight
bit and the corresponding guide ring.
Second side of the template
(to be used with the straight bit)
First side of the template
(to be used with the dovetail bit)
17
www.cmtutensili.com