Optional Cmt300-T190 Template - CMT ORANGE TOOLS CMT300 Manual De Instrucciones

OPTIOnAL CMT300-T190 TeMPLATe

9) Optional CMT300-T190 template
The CMT300-T190 template can be purchased as an optional and enables to make 19x22mm open dovetail
joints.
20/30mm
Open dovetail joints
(CMT300-T190)
19mm
(3/4")
Contents of the CMT-T190 package:
32) CMT300-T190 template
14) Four M4x8mm screws
46) Two Ø16.3x6mm stop rings
10) Two M4x16mm screws
from
CMT300
36) Ø22x4mm guide ring
22) Four M5x8mm screws
23) 2.5mm hex key
from
CMT300
from
CMT300
Assembling the template: this template is mounted in the
Overhead view
same way as the standard model. Remove the standard
template from the CMT300 system and replace it with
template 32, fixing it on the supports (13 - included in the
CMT300 package), using the screws (14). The stop rings
(46) replace those supplied as standard and are mounted
Front view
on the front in F2.
Mounting the guide ring: it can be seen that this template has two sides, as the joint is made using two
bits: one for each side of the template. On the first (straight) side, the Ø19mm dovetail bit (718.190.11
Ø6mm shank – 818.190.11 Ø6.35mm shank – 918.190.11 Ø8mm shank – 918.690.11 Ø12mm shank
– 818.690.11 Ø12.7mm shank) will be used, with the Ø22x4mm guide ring (36) supplied with the template,
whereas on the other (dovetail) side, the Ø12.7mm straight bit (812.127.11 Ø6.35mm shank – 912.127.11
Ø8mm shank – 811.627.11 Ø12.7mm shank) will be used with the standard Ø15.8x4mm ring, supplied
with the template.
16
www.cmtutensili.com