Muskoka Dwyer Instrucciones De Montaje página 3

GET rEAdy To sTArT
Before assembly, use scissors to unwrap the parts from the packaging.
DO NOT use a box cutter or exacto-knife as you may cut into the
mantel pieces inside the box and damage the finish. Check for the
hardware bag which is RED and located inside the packaging, taped
to the top box. Be sure you DO NOT discard any pieces.
Step 1
Locate base (1) and place it on the floor. Do not put it up against
the wall at this point in the assembly, as you need to get in behind
the mantel during assembly.
Step 2
Insert 4 cam lock dowels (d) into the holes shown on base (1). Make
sure the threaded side is down so you can insert and tighten each
cam lock dowel (d) into each hole in base (1).
Step 3
Locate the right side panel interior (4) and the left side panel interior
(5). Insert 2 wood dowels (a) into the 2 holes at the bottom edge of
each of the right side panel interior (4) and left side panel interior
(5). Insert 2 cam locks (e) into holes at the base of each of the right
side panel interior (4) and left side panel interior (5). Make sure the
arrows on the 4 cam locks (e) are pointing downward toward the
base (1).
Step 1
Step 2
Hardware used
d Cam lock Dowels
Step 3
Hardware used
a wood Dowel
e Cam lock
2
1
d
1
4
e
5
a
1
a
x 4
x 4
x 4