Muskoka Dwyer Instrucciones De Montaje página 9

Step 19
Locate the fireplace insert. Install fireplace insert from the back of
the mantel. Once you have the fireplace insert into position and
square at the front, locate fireplace insert brace (15). Press fireplace
insert brace (15) up against the back of the fireplace insert making
sure that you DO NOT cover any air venting. Once the fireplace
insert brace (15) is snug, insert and tighten 2 medium flat head
wood screws (J) into the base (1) to attach it to the mantel securely.
Your fireplace insert is now sitting firmly in place.
You must attach the anti-tipping device to the mantel and the wall.
This device is a safety feature that will prevent the mantel from
tipping over. Applied weight may cause mantel imbalance.
Step 20
Attach one of the mounting brackets (n) securely to the back
underside edge of the mantel. Use 2 flathead small screws (o) to
make sure it is secure.
Step 21
Determine where mantel is to be placed and mark location on the
wall for the mounting bracket (n) screw holes. The mounting bracket
(n) on the wall should be positioned vertically. Insert a wall anchor
(q) into each screw hole in the wall. Place the mounting bracket (n)
over the marks on the wall and use the large screws (p) to securely
attach the mounting bracket (n) to wall.
Step 19
Hardware used
J flat Head
Medium Screw
Step 20
Hardware used
o flat Head
Small Screw
n Mounting
Bracket
Step 21
Hardware used
q wall Anchor
p flat Head
large Screw
n Mounting
Bracket
8
J
FIREPLACE
INSERT
15
x 2
EDGE OF
MANTEL
BRACKET
n
SMALL
SCREWS
o
x 2
x 1
q
n
p
WALL
x 2
x 2
x 1