Mopar 4280359 Manual Del Usuario página 25

25
84. Connect and install the HVAC controls (1).
85. Install the defroster grille (1).
86. Install the A­Pillar trim (1). Repeat on the opposite
side.
87. Reconnect the negative battery cable.
RESTORE VEHICLE CONFIGURATION
NOTE: The technician should have cut the KEY FOBIK Blanks using the original vehicle's Key FOBIK as a tem­
plate. Please make sure the KEY FOBIK Blanks have been cut prior to programming. If this step has not been
performed, please perform at this time.
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Prior to programming, have the vehicle PIN readily available before running the routine. If necessary,
obtain the four digit PIN from the dealership's parts department.
CAUTION: If the PCM and WCM are replaced at the same time, the PCM MUST be programmed before the WCM.
1. When prompted, enter the four digit pin number obtained from the dealership parts department.
2. Connect a battery charger to the vehicle.
3. With the wiTECH diagnostic application, perform the following steps form the Initial Start Up Screen:
• Select the "DIAGNOSTIC PROCEDURES" tab
• Highlight "RESTORE VEHICLE CONFIGURATION"
• Select the "Run Diagnostic" button
• Select "CONTINUE"
• Verify that the vehicle VIN number is correct
• Once verified, select the "Correct VIN" button
4280359
Jan 19, 2011 K6861247