Setup"/"Gen.SErv." Menu - Sartorius Entris BCE6202 Instrucciones De Manejo

Parameter Setting values
UNIT GRAM*,
KILOGR ., CARAT,
POUND,OUNCE,
TROY .OZ .,
HKTAEL,
SNGTAEL,
TWNTAEL,
GRAINS,
PENNYWT .,
MILLIGR ., PART ./
LB, TL ./CHINA,
MOMMES,
AUSTR .CT, TOLA,
BAHT,
MESGHAL,
NEWTON
DISP .DIG . ALL*
LP .ON .OFF
MINUS 1
CAL ./ADJ . EXT .CAL .
E .CAL .USR .
INT .CAL .*
CAL .SEQ . ADJUST*
CAL .-ADJ .
ON Z/T ON*
OFF
ISOCAL OFF
NOTE
ON*
EXT .CAL . UNLOCKED*
LOCKED
* Factory setting
7.3.2

"SETUP"/"GEN.SERV." Menu

Parameter Setting values
MENU .RES . YES
NO*
* Factory setting
Explanation
− The device displays the weight in the selected unit .
− The availability of units depends on national legislation and is therefore country-specific .
"Show all decimal places": All decimal places are shown in the display . The setting change is
not available on conformity-assessed devices .
"Reduced by 1 decimal place for load change": The last decimal place on the display is switched
off until stability is achieved .
"Last decimal place off": The last decimal place is switched off .
The [Adjust] button starts an external calibration and adjustment process with the preset
calibration weight .
The [Adjust] button starts an external calibration and adjustment process with the user-
defined calibration weight value .
The [Adjust] button starts an internal calibration and adjustment process .
The adjustment starts automatically after the calibration .
The adjustment must be started or exited manually after calibration with the [Confirm] button .
Activates the initial taring/zeroing . The device is tared or zeroed after it is switched on .
Deactivates the initial taring/zeroing: After it is switched on, the device shows the same value
as before it was last switched off .
Switches the isoCAL function off .
If the balance needs to be calibrated: The [isoCAL] button flashes . The isoCAL function must be
manually triggered with the [Adjust] button .
Activates the isoCAL function . The device is automatically adjusted as soon as a trigger starts
the isoCAL function .
Activates the external calibration/adjustment function under [CAL ./ADJ .] .
Deactivates the external calibration/adjustment function under [CAL ./ADJ .] .
Explanation
Resets the system settings to the factory default settings .
Deactivates the option of resetting the device menu .
System Settings
Entris ® BCE Operating Instructions 19