Securing Your Child In The Car Seat; Care And Maintenace; Soft Goods Assembly - Joie tilt Manual De Instrucciones

The assembled vehicle safety belt is shown in 38
!
Ensure vehicle shoulder belt passes through Lock-off Device, as shown in
!
Ensure vehicle waist belt passes through the forward-facing vehicle waist belt slots, as shown in
!
Ensure that the vehicle buckle tongue is engaged with the buckle correctly, as shown in

Securing your Child in the Car seat

Note
1. When installing the car seat in the forward-facing mode, DO NOT use the infant body support.
2. Please install the car seat on the vehicle seat first, and then place the child in the car seat.
3. After the child is placed into the car seat, check whether the shoulder harness straps are at the
proper height. Please refer to Proper Position of the Shoulder Harness Straps
Straps Height Adjustment.
1. Pull up the webbing adjuster, while pulling the shoulder harness straps to the proper length.
- 1
8 Webbing adjuster
2. Press the red button to disengage the buckle
right sides of the car seat. 9
3. Place the child in the car seat and pass both arms under the shoulder harness straps.
!
After the child is seated, recheck whether the shoulder harness straps are at the proper height.
Please refer to Proper Position of the Shoulder Harness Straps
Adjustment. 22
4. Pull down the adjustment webbing and adjust the harness so that your child is snugly secured.
!
Make sure the space between the child and the shoulder harness straps is about the thickness of
one hand.
Care and Maintenance
!
Please machine wash the soft goods with cold water under 30°C.
!
Do not iron the soft goods.
!
Do not bleach or dry clean the soft goods.
!
Do not use undiluted neutral detergent, gasoline or other organic solvent to wash any part of the car seat.
It may cause damage to the car seat. Use only mild detergent and water with a soft cloth to clean car seat
shell and harness.
! Do not twist the soft goods to dry with great force. It may leave the soft goods with wrinkles.
! Please hang dry the soft goods in the shade only. Do not use a clothes dryer to dry the fabric.
! Please remove the car seat from the vehicle seat if not in use for a long period of time. Place car seat out of
reach from your child.
!
Foam insert MUST be removed from infant body support before machine washing. To reinstall foam into
infant body support, please reference 6 .
19
.
- 1
38 .
- 3
38 .
& Shoulder Harness
- 1
9 , and then leave the harness straps on the left and
39
& Shoulder Harness Straps Height

Soft Goods Assembly

1. Place the seat pad on the shell and thread the buckle through the seat pad slot.
- 2
38 .
2. Wrap the crotch pad around the crotch strap and fasten the velcro.
3. Thread the adjustment webbing and harness on both sides through the seat pad respectively.
4. Place the fastening pieces in front of the seat pad into the two slots on the bottom of the seat shell.
5. Place the fastening pieces on sides of the seat pad into the two slots on both sides of the seat shell.
6. Put the infant body support into the car seat and engage the buckle.
7. Refer to
The assembled soft goods are shown in
8
- 1
39
Assembly of the Shoulder Harness for the remaining steps.
45 .
40
41
42
43
44
20