Remote Control Procedures - Luminance Brands Kathy Ireland Home FLORET ECO CF840BQ00 El Manual Del Propietario

8.1: Preset Memory Feature
Your Receiver is equipped with a preset memory
feature. If the AC supply to the Receiver is powered
through a wall switch, when the switch is turned OFF,
the Control will remember the Light Intensity and Fan
Speed.
8.2
The Remote Control Transmitter is powered by One
CR2032 Lithium Battery (included).
Removal of Cover:
Remove and Retain the Battery Cover Phillips Head
Screw (Figure 36).
Press down and pull back on the Remote Control
Battery Cover Lip (Figure 36).
Install one new CR2032 Lithium Battery into the Battery
Compartment following the correct Battery placement
printed on the Compartment (Figure 36).
NOTE: Dispose of cell batteries properly and keep
away from children. Even used cell batteries may
cause injury.
WARNING
!
Chemical Burn Hazard. Keep batteries away from
children. Always completely secure the battery
compartment. If the battery compartment does not
close securely, stop using the product, remove the
batteries, and keep it away from children. This remote
contains a lithium button/coin cell battery. If a new
or used lithium button/coin cell battery is swallowed
or enters the body, it can cause severe internal burns
and can lead to death in as little as 2 hours. If you
think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical
attention. Dispose of cell batteries properly and keep
away from children. Even used cell batteries may
cause injury.

8. Remote Control Procedures

When the Switch is turned back ON the Light and Fan
will resume operation as they were prior to the Switch
being turned OFF.
Figure 36
21
Please contact 1-800-777-4440 for further assistance
21
luminancebrands.com
ETL Model No.: CF840