Publicidad
Idiomas disponibles
Idiomas disponibles
SWITCHING ON / SWITCHING OFF
Before connecting the jigsaw to a power supply always check that power supply voltage matches rated
voltage on the label fixed on the power tool.
Switching on – press the switch button (1) and hold in this position.
Switching off – release pressure on the switch (1).
Locking the switch (continuous operation)
Switching on:
● Press the switch button (1) and hold in this position.
● Press the switch lock button (2) (fig. E).
● Release pressure on the switch button (1).
Switching off:
● Press and release the switch button (1).
CONTROL OF JIGSAW OPERATION SPEED
You can control rotational speed of jigsaw motor by turning and setting the work speed control wheel (9)
in desired position. It allows to adjust the power tool working speed to match characteristics of processed
material. Speed control range is 1 to 6.
The bigger the number on the wheel rim (9) (fig. F), the greater the jigsaw operation speed.
BLADE PENDULUM ACTION CONTROL
Besides reciprocating movement control there is also possibility to set blade pendulum action level. It al-
lows for better adjustment of the tool operation parameters to type of processed material. Pendulum ac-
tion is controlled in steps with the switch for pendulum action setting (10) and its range is 0 to III (fig. G).
The table below gives the best choices of pendulum action setting for various materials:
Sheet metal plate, generally: 0
Sheet aluminium: I – II
Plywood: 0 – I
Set the switch for pendulum action to 0 when using knife blade. Lubrication is recommended for
metal cutting.
FOOTPLATE ADJUSTMENT FOR BEVEL CUTTING
Disconnect the power tool from power supply.
Adjustable jigsaw footplate allows to make a bevel cut in the range from 0
● Use the hexagonal key and loosen the footplate (5) fixing screws.
● Move the footplate (5) backwards and tilt right or left (up to 45
● Set the footplate (5) at desired angle, move forward and tighten fixing screws to secure it (fig. H).
Scale allows for setting the footplate to angles: 0°, 15°, 30° or 45° (right or left). Always put the hexagonal
key in its storage place after adjustment has been made.
INSTALLATION OF EDGE GUIDE
Disconnect the power tool from power supply.
Guide for parallel cutting may be installed on left or right side of the jigsaw footplate.
● Loosen the edge guide locking screws (12).
OPERATION / SETTINGS
Steel sheet: 0 – I
Plastics: I – II
Wood: I - III
19
to 45
(to either side).
0
0
).
0
Publicidad
