Carl F. Bucherer PATRAVI EVOTEC POWERRESERVE Instrucciones página 3

Patravi evotec powerreserve
Legend
Day of the week
Big date
crown
Position 1: Winding
1 2 3
Position 2: set date / day of the week
Position 3: set time
Power reserve
small seconds
En 6
Your watch
the mechanism of the Patravi Evotec Powerreserve
is based on the innovative cFB A1000 manufacturer
calibre with a peripheral rotor. Measuring 43.75 ×
44.5 mm, the cushion-shaped case of the timepiece
has generous measurements. It includes a clearly
set-up dial on which there is room for an innovative
power reserve indicator, big date, day indicator and
small seconds dial.
Technical Data
Automatic movement cFB A1002
Depth of the movement 6.3 mm
Diameter of the movement 32 mm
number of jewel bearings 33
Water resistance 50 m (5 atm)
(see the chapter on "Water resistance")
Start the watch Set time
the movement is wound by the motion of the In order for the date to properly move at midnight,
wrist when worn. When not worn, the watch stops the hour hand must intentionally be set to a.m. or
after approximately 55 hours and has to be wound p.m. based on the current time.
manually.
1 rotating the crown in the 1
counter clockwise direction
will automatically release it
to position 1.
2 rotate the crown clockwise 2
until the power reserve
indication hand has left the
LoW area.
3
Pull the crown until it is in
position 3. the second hand
does not move.
rotate the crown clockwise
until the date changes. then
deliberately set the current
time either a.m. or p.m.
Push the crown back into
position 1. the second hand
is back in motion.
7 En