3. Switch "ON" the flash unit and press the camera's shutter button
halfway. (The aperture value and film speed are now
automatically transmitted to the slave flash unit.)
4. Remove the slave flash unit from the camera.
5. Press the MODE button and select the
Mode)
6. Press the SEL button to make the channel display indicator
blink.
7. Press the
+ or – button to set the channel number. (C1 or C2)
8. Press the SEL button to make the output amount (
9. Press the
+ or – button to set the flash output amount.
■ Set the flash power by setting the distance indicator on the LCD panel to coincide as closely as
possible with the actual distance from the slave flash to the subject. If the actual distance is out of
range, you need to change the aperture value.
10. Press the SEL button several times to make the display stop blinking.
11. Place the slave unit in the desired location. Do not place the slave unit within the picture area.
Setting for Slave Controller unit
12. Attach the Slave Controller flash unit to the camera body.
13. Press the MODE button and select the
Mode).
14. Press the SEL button to make the channel display indicator
blink.
15. Press the + or – button to set the same channel number as
that set on the firing flash unit.
16. Press the SEL button to make the flash output amount (
17. Press the SEL button to make the display stop blinking. (
will appear)
18. After confirming that all flash units are fully charged, press the shutter button to take the picture.
■ When the firing flash unit of EF-610 DG SUPER SA-STTL is fully charged, the AF Auxiliary Light will
blink.
■ As the slave control using is in
changed.
■ The Slave Controller unit functions only to control the slave unit.
SPECIFICATIONS
TYPE : Clip-on type serial-controlled TTL auto zoom electric flash
GUIDE NUMBER : 61 (ISO 100/m, 105mm head position)
POWER SOURCE : Four AA type alkaline batteries or Four AA type Ni-Cd batteries or,
RECYCLING TIME : about 7.0 sec. (Alkaline batteries)
NUMBER OF FLASHES : about 120 flashes (Alkaline batteries)
FLASH DURATION : about 1 / 700 sec. (full power firing)
FLASH ILLUMINATE ANGLE : 24~105mm motor powered control (17mm with Built-in Wide Panel)
AUTO POWER OFF : Available
WEIGHT : 330g / 11.6oz.
DIMENSIONS : 77mm (W) / 3.0in. x 139mm (H) / 5.5in. x 117mm (L) / 4.6in.
23
: Four AA type Ni-MH Nickel-Metal Hydride batteries
: about 5.0 sec. (Ni-Cd, Ni-MH Nickel-Metal Hydride)
: about 160 flashes (Ni-Cd, Ni-MH Nickel-Metal Hydride)
/
. (Slave
) display indicator of the flash blink.
/
(Slave
mode, the aperture on the slave control unit can not be
) display indicator blink.
mark disappear and, channel display