Starting The Machine For The First Time; Connecting To The Water Supply; Electrical Connection And First Use - La Pavoni LPSGEG03 Instrucciones De Uso

controller
30. Service boiler PID temperature
controller
31. Service boiler ON / OFF switch
32. Service boiler ON/OFF indicator light
33. Pressure gauge - BPPC (Brewing
Pressure Profiling Control)
34. "BPPC" adjustment lever*
*standard on LPSGEG03 models
**standard on LPSGEV03 models
4. STARTING THE MACHINE FOR
THE FIRST TIME
4–1. CONNECTING TO THE WATER
SUPPLY
The LPSGEG03 and LPSGEV03 machines
can either be used with a water tank (2)
or connected to the mains water supply
using the hose provided (17).
In order to use the machine with a
water tank (2), the switch (C) has to be
in position "I"" (this should be done with
the machine switched off) (Fig. 1-2).
To use the machine connected to the
water supply:
• Place the switch (C) to position "II"
(this should be done with the machine
switched off) (Fig. 1-2).
• Connect the hose (17) to the fitting (D)
located under the machine and then
connect it to the water supply (Fig. 1).
• It is recommended that you
install a water softener on the
machine water supply system.
• Make sure that the water in
the water supply that you will
be connecting the machine to is
potable.
• This appliance should be
connected to the water supply
in compliance with the national
Legislation of the country in which
it is used.
• The maximum inlet pressure
to the machine from the water
supply must not exceed 0.65 MPa.
If it is higher than 0.5 MPa (5 bar),
it is recommended that you install
a balanced pressure regulator for
high pressures.
4–2. ELECTRICAL CONNECTION AND
FIRST USE
To start the espresso coffee machine,
carefully follow the instructions below:
• Open the package, take out the
machine and make sure that it is not
damaged.
• Place the machine on a level surface,
remove the cover, take out the water
tank (2) and rinse it.
• Fill the tank with clean water, put it
back in its seat, and insert the silicone
tubes. Close the machine cover.
• If you connect the machine to the
water supply, make sure that the water
supply tap is open before switching on
the machine.
• Water can be drained directly into
a drainage outlet by removing the
plug (A) from the drip tray (13) and
connecting the silicon tube (28) to the
tray (B) (Fig. 1).
Before connecting the machine,
make sure that the mains power
voltage is the same as the one
indicated on the data plate
located under the base of the
machine.
• Insert the plug into the power socket.
• Before starting the machine, place the
filter holder (12) into the group head
(11); place a container under the group
head and move the lever (15) upwards
in order to fill the coffee boiler.
• Turn on the machine by placing the
on / off switch (1) to position "I". Wait
21