Cleaning The Outside Of The Machine; Cleaning The Coffee Machine Components - La Pavoni LPMGCM03 Manual De Uso

Let the coffee machine cool down
before cleaning.
5–1. CLEANING THE OUTSIDE OF THE
MACHINE
To keep the outer surface of the coffee
machine in good condition, it
should be cleaned regularly after use.
Let the appliance cool down first. Clean
with a soft, damp cloth.
5–2. CLEANING THE COFFEE MACHINE
COMPONENTS
CLEANING THE COFFEE FILTERS
Clean the coffee filters regularly under
running water. If the holes are blocked,
clean them with a pin or a brush.
CLEANING THE TURBO STEAM NOZZLE
• To avoid altering the taste of the drinks
to be heated and to prevent the holes
at the end of the turbo steam nozzle
(6) from becoming clogged, after use,
turn the steam knob to dispense a
small amount of steam and remove
any milk from the inside of the nozzle.
Then clean thoroughly with a damp
cloth.
• In addition to cleaning the steam
nozzle immediately after each use, we
recommend that every now and again
you clean it more thoroughly (Fig. G).
• Remove the nozzle cover (E) by pulling
it downwards.
• Turn the threaded locking ring (A)
anticlockwise until the steam nozzle is
released.
• Clean the injector (D) in warm water to
remove any milk residues and, using a
needle, clean the hole at the end of the
steam nozzle that may have become
blocked by hardened milk.
• After cleaning, reassemble as follows:
• Insert the threaded locking ring (A)
and the grommets (B) and (C) onto
the steam nozzle. Insert the injector
(D) as far as it will go onto the steam
nozzle and tighten the locking ring (A)
clockwise as far as possible in order to
secure the injector in place.
• Push the nozzle cover (E) upwards
onto the injector.
CLEANING THE AUTOMATIC
CAPPUCCINO MAKER
• Place a full glass of water next to the
machine in which to immerse the
Suction tube.
• Proceed as if you were preparing
a normal cappuccino, allowing the
dirty water to drain into a suitable
container.
• To replace the steam pipe (12), follow
the instructions in section 4.9.
• In addition to cleaning the Automatic
Cappuccino maker after each use,
every now and again clean it more
thoroughly.
• Turn the threaded locking ring (A)
anticlockwise until the steam nozzle is
released (Fig. G).
• Remove the cover (D), the pin (C) and
the pipe (B) and wash them thoroughly
under warm running water to
eliminate residues or hardened lumps
of milk. Then replace the components
in the reverse order.
CLEANING THE GROUP HEAD
• It is recommended that you rinse the
group head by turning on the coffee
/ hot water dispensing button (10)
without the filter holder inserted
CLEANING THE WATER TANK
• It is recommended that you
periodically clean the water tank by
carefully removing it from its housing
by its handle and then putting back the
water pipes.
27