Brill 42 BFR Manual Del Usuario página 24

nearest authorised specialist
dealer.
Caution! Repairs that
GB
A
require specialist knowl-
edge must only be carried
out by an authorised specialist.
Caution! For safety reasons,
A
only use original spare
Fault
Abnormal noises,
lawnmower rattles.
Lawnmower does not run
smoothly or vibrates vigorously.
Motor does not start.
Engine starts up and
then stops.
Motor starts for a short time
then suddenly stops with a loud
bang.
Petrol leaks out when in
the parking position.
Lawn turning yellow,
cut not clean.
Whistling noise.
Wheel drive not
functioning.
Mower leaves deep tracks.
24
parts supplied by the manufac-
turer or parts that have been
authorised by the manufacturer.
We expressly point out that in
accordance with product liability
laws, we are not liable for any
damage caused by our units if
this damage is due to improper
repair or if parts exchanged are
Possible Cause
Bolts at motor, its fixings or
mower housing are loose.
Blade or blade flange damaged
(unbalanced), screw loose.
Blade flange loose on the motor
shaft.
Primer was not operated
when starting the motor.
No fuel, fuel tank empty.
Spark plug defective or
fuel tank empty.
Tank cap valve not open
Ventilation in the tank cap
blocked.
Cylinders, pistons and bearing
of crankshaft have seized.
No motor oil in crankcase.
Tank cap valve not open.
Blade is too blunt,
cutting height too low.
V-belt slipping.
Drive belt broken.
Clutch cable stretched.
Ground softened by water,
lawn too wet.
not our original parts or parts
approved by us, and if the
repairs were not carried out
at service centre authorised by
the manufacturer or by an
authorised specialist. The same
applies to spare parts and
accessories.
Remedy
Tighten bolts.
Retighten the screws.
Have damaged parts replaced
by the service station.
Press the primer several times
(see Putting your Lawnmower
into Operation).
Clean spark plug and / or
fill the fuel tank.
Valve in the tank cap valve open
– clean the drill hole in the tank
cap from the inside using
a pointed object.
– Contact specialist workshop /
service centre.
Motor overhaul at specialist
workshop required.
Close the valve in the tank cap.
Change blade and / or use
a slightly higher cutting height.
Contact specialist workshop /
service centre.
Drive belt is to be replaced.
Obtain assistance from
a Brill Service Station.
Readjust the clutch cable.
Allow lawn to dry,
do not mow if grass is wet.