Simon, Evers & Co HPN 25 S Instrucciones De Servicio página 40

OF THE WHEELS, THE LEVER DEVICE, THE FORKS AND THE RAISING
AND LOWERING CONTROL.
4. NEVER USE THE UNIT ON SLOPES.
5. ENSURE THAT PARTS OF THE BODY BECOME CAUGHT IN THE LIFTING
MECHANISM, UNDER THE FORKS OR UNDER THE LOAD. NEVER
TRANSPORT PEOPLE ON THE UNIT.
6. THE OPERATOR SHOULD WEAR GLOVES AND SAFETY SHOES FOR HIS
OR HER OWN SAFETY.
7. NEVER TRANSPORT UNSTABLE OR LOOSELY STACKED OBJECTS.
8. NEVER OVERLOAD THE UNIT.
9. NEVER LOAD THE PLATFORM ON ONE SIDE OR MAKE IT TOP-HEAVY
OR PLACE LOADS THAT STICK OUT OVER THE EDGE OF THE
PLATFORM.
10. THE CAPACITY OF THE UNIT ASSUMES THAT THE LOAD WILL BE
PERFECTLY BALANCED FOR TRANSPORT WITH THE CENTRE OF
GRAVITY IN THE CENTRE OF THE FORKS AT THE FRONT.
11. ENSURE THAT THE LENGTH OF THE FORKS IS THE SAME AS THE
LENGTH OF THE PALLET.
12. LOWER THE FORKS AS FAR AS POSSIBLE WHEN THE UNIT IS NOT IN
USE.
II . To install the drawbar on the base unit
1) Undo the setting screw (324) in the lever (325).
2) Undo the three screws (D611) and the three spring rings (D616) on the base plate.
3) Place the drawbar on to the base plate threading the chain and the wire pin (D609) through
the hole in the centre of the plate (347) and axle (345).
4) Refit the three screws (D611) and the sealing rings (D616) back into the plate and tighten
them.
5) Raise the lever (325) and place the wire pin and the chain (D609) into the notch in the
lever (325).
III. To adjust the lever functions
The control lever (D608) can be set to three positions:
LOWER = to lower the forks
NEUTRAL = to drive the unit
ASCENT = to raise the forks
1) Tighten the setting screw (324) in the handle (325) until the "LOWER" setting works.
2) If the forks can only be raised when the control lever is in the "NEUTRAL" position, the
setting screw (324) must be turned clockwise until the pump function to raise the forks has
been disabled and the "NEUTRAL" setting therefore works properly.
- 3 -