Cebora Sound MIG 3840/T Manual De Instrucciones página 16

H2O flashes on the display O to indicate low pressure
(control panel instructions).
2.3.3 DESCRIPTION OF THE COOLING UNIT (Fig. 1)
BX - Slot:
Slot to inspect the coolant fluid level
BQ - Quick-fitting sockets:
Use only for TIG welding systems.
NOTE: they must not be linked together.
BW - Cap.
BT - Quick-fitting valves:
Connect the red and blue lines of the wire feeder/machine
connection.
NOTE: Match the hose and socket colours correctly.
2.3.4 INSTALLATION
Unscrew the cap BW and fill the tank (the equipment is
supplied with approximately one liter of fluid). It is impor-
tant to periodically check, through the slot BX, that the
fluid remains at the "max" level. As a coolant, use water
(preferably deionized) mixed with alcohol in percentages
defined according to the following table:
temperature
0°C up to -5°C
-5°C up to -10°C
NOTE If the pump turns with no coolant present, you
must remove all air from the tubes.
If so, turn off the power source, fill the tank, disconnect
the fitting of the power source/wire feeder connection
A
V
AY
N
S
T
1
2
3
R
4
5
U
AI
16
water/alcohol
4L/1L
3.8L/1.2L
B C D O E W
AO AJ AP AK AQ X
from the fitting BT(
other end of the hose in the tank. Start the power source
for approximately 10/15 seconds, then connect the hoses
of the power source/wire feeder connection.
2.4 TROLLEY (Fig. 1)
BY - Cylinder support.
BZ - Cylinder holding straps.
3 DESCRIPTION OF THE PANEL (Fig. 2)
The panel commands are divided into 4 sectors, plus a
menu of secondary functions, and are described in the
following paragraphs:
3.1 Setting up the welding process
3.2 Accessory functions for the P1 panel
3.3 Displaying and adjusting the welding parameters
3.4 Service functions
3.5 Secondary functions menu
3.1 SETTING UP THE WELDING PROCESS
3.1.1 AI Button - Choosing the welding process.
Each time this button is pressed, the LED corre-
sponding to the selection lights.
LED R1
Pulsed synergic MIG/MAG welding.
LED R2
Non-pulsed synergic MIG/MAG welding.
F G H P I Y
AR AL AS AT AX
) and connect a hose. Insert the
J K L M
Z
Q
AC
AA
AD
AH
AG
AF
AN1
AB
AE
AN2
AM
Fig. 2