Installation Steps - AVS Bugflector Instrucciones De Instalación

Installation Steps

Press (1) large hood insert into the hole.
Repeat for the other side.
3
Press (1) small hood insert into each exposed hole.
5
hole
hood
large hood insert
hood shield
washer
large screw
7
DO NOT OVER TIGHTEN
If necessary, replace broken fasteners as shown.
Receptacle
Screw
Rubber Trim
9
NOTE: Actual application may vary slightly from illustrations.
hood
PROFILE VIEW
Align shield to hood. Remove & discard weatherstripping
4
Set shield on hood. Place center tabs under weatherstripping.
6
hood
small hood insert
hood shield
small screw
8
Adjust bumper stops as needed to ensure hood shield clears grille
10
Page 2 of 3
fasteners where tabs align.
hole
washer
DO NOT OVER TIGHTEN
and headlights.