Positioning And Securing Your Child Without Backrest - Britax Parkway SG Guia Del Usuario

Positioning the Booster Seat

Positioning and Securing Your Child without Backrest

WARNING!
• DO NOT use a lap belt only to secure the child. Always use a
lap and shoulder belt with this booster seat.
• DO NOT use this booster seat without the backrest unless the
booster seat will be properly installed in a vehicle seat with a
head restraint.
• ONLY use this booster seat without the backrest if proper
vehicle seat belt positioning can be achieved—when the
vehicle seat belt's shoulder part crosses the chest and center
of the child's collar bone. Ensure the lap part of the vehicle
seat belt sits low across the child's upper thighs and that the
shoulder part does not contact the child's neck.
• Never route the shoulder part of the vehicle seat belt under
the child's arm or behind their back.
• Use the red belt guides on the child seat to ensure proper fit.
• An improperly positioned vehicle seat belt can allow the lap
part to ride up into the abdomen and cause serious injury in
the event of a crash.
Note: Before using the booster seat without the backrest, you
may need to complete the removal instructions on page 15.
1 Place the booster seat base on the
vehicle seat.
2 Pull the vehicle seat belt from the
retractor, positioning the lap belt under
both armrests and over both red belt
guides (Fig. A).
22
All manuals and user guides at all-guides.com
3 Verify that the vehicle seat belt is not twisted and then
4 Adjust the vehicle seat belt's shoulder
5 Route the lap part of the vehicle seat belt
6 Remove slack from the vehicle seat
7 Verify secure installation.
a
Positioning the Booster Seat
fasten across the child.
part so that it crosses the chest and
center of the child's collar bone (Fig. B).
through the SecureGuard clip (Fig. C).
* Ensure the bottom edge of the SecureGuard
clip is level with your child's upper thighs.
belt.
* Proper positioning is achieved when the vehicle
seat belt's shoulder part crosses the chest and
center of the child's collar bone.
Check that the:
9Vehicle seat belt is not twisted.
9Vehicle seat belt is securely fastened.
9Lap part of the vehicle seat belt is routed through the
SecureGuard clip.
9Vehicle seat belt is properly positioned low across the
child's upper thighs and does not contact the child's neck.
b
c
23