Positioning The Booster Seat; Positioning And Securing Your Child With Backrest - Britax Parkway SG Guia Del Usuario

Positioning the Booster Seat

Positioning and Securing Your Child with Backrest

WARNING!
• DO NOT use a lap belt only to secure the child. Always use a
lap and shoulder belt with this booster seat.
• Ensure the lap part of the vehicle seat belt sits low across
the child's upper thighs and that the shoulder part does not
contact the child's neck.
• Never route the shoulder part of the vehicle seat belt under
the child's arm or behind their back.
• An improperly positioned vehicle seat belt can allow the lap
part to ride up into the abdomen and cause serious injury in
the event of a crash.
Note: Before using the booster seat for the first
time, you will need to complete the assembly
instructions on page 14.
1 Place the booster seat on the vehicle seat.
2 Push the backrest until it rests against the
vehicle seat back (Fig. A). If the vehicle seat
back is adjustable, move it to the normal
upright position.
Note: If needed, adjust or remove the vehicle's
head restraint to allow the backrest to lie flat
against the vehicle's seat back.
3 Have your child sit in the booster seat and
check the head restraint for proper height
adjustment (Fig. B).
Note: Adjust the head restraint so when seated, the top of the child's
ears are below the top of the head restraint and the vehicle shoulder
belt will be appropriately positioned at or above the child's shoulder
through the shoulder belt guide.
20
All manuals and user guides at all-guides.com
4 Pull the vehicle seat belt out and route the
5 Route the lap part of the vehicle seat belt
6 Verify that the vehicle seat belt is not twisted
7 Route the lap part of the vehicle seat belt
8 Remove slack from the vehicle seat belt.
a
9 Verify secure installation.
b
Positioning the Booster Seat
shoulder part of the vehicle seat belt through
the upper belt guide (Fig. C).
under both armrests, over your child's upper
thighs and over both base belt guides (Fig. D).
and then fasten the vehicle seat belt across
the child (Fig. E).
* The lap part of the vehicle seat belt should rest
low on the child's upper thighs.
through the SecureGuard clip (Fig. F).
* Ensure the bottom edge of the SecureGuard clip
is level with your child's upper thighs.
* Proper positioning is achieved when the vehicle
seat belt's shoulder part crosses the chest and
center of the child's collar bone.
Check that the:
9 Vehicle seat belt is not twisted.
9 Vehicle seat belt is securely fastened.
9 Shoulder part of the vehicle seat belt is routed
through the shoulder belt guide.
9 Lap part of the vehicle seat belt is routed
through the SecureGuard clip.
9 Vehicle seat belt is properly positioned low across the child's
upper thighs and does not contact the child's neck.
c
d
e
f
21